Controls line placement through dimension points that are aligned horizontally or vertically on the drawing sheet. Use this option to place a line that is separate from the dimension but aligned with the dimension's witness line.
-
If you select On, the software places a separate line through all vertically or horizontally aligned dimension points.
1 - Equipment object |
-
If you select Off, the software does not place a separate line through multiple aligned objects.
1 - Equipment object |
-
You can place lines in a vertical or horizontal direction, depending on the alignment of the objects. However, diagonal placement for diagonally aligned objects is not supported.
-
The following dimension geometric analyzer modules use the Place Lines property:
-
Default (DrawingGeometricAnalyzer)
-
Margin (DrawingGAMarginOnly)
-
-
The following options allow you to manually edit the .xml file:
-
Type -1 to place lines.
-
Type 0 to suppress lines.
-
-
Enclose either of the above values within the following .xml tags.
<placeLines>-1</placeLines>