Determines the location of the point that the software places on a straight or turn feature.
XML value |
||
---|---|---|
Center At the centroid of the area of a closed shape (that is, the geometry must be a closed curve). The centroid cannot be on the curve. |
0 |
|
Middle At the middle point of a curve. |
1 |
|
Inmost At the innermost point inside the area of a closed shape (that is, the geometry must be a closed curve). |
2 |
|
At first end At the first end point of curve. |
3 |
|
At second end At the second end point of curve. |
4 |
|
Right On the right side of the range box for the curve. |
5 |
|
Left On the left side of the range box for the curve. |
6 |
|
Top On the top of the range box for the curve. |
7 |
|
Bottom On the bottom of the range box for the curve. |
8 |
|
Box center At the center of the range box for the curve. |
9 |
|
Default location Default location for the curve. |
10 |
|
At curve ratio At the curve ratio along the curve. |
12 |
|
Used with the curve ratio property. Used with positioning modules that use their start curve ratio and end curve ratio property. |
The possible values for Location ID when using the Profile Weld Point point generator are limited to Top, Bottom, or Middle.
-
The following point generators use the Location ID property:
-
Weld Point (DrawingPGWelds)
-
Profile Weld Points (SMDwgProfileWeldsPG)
-
Inside or Along 2D Curve (InsideOrAlongCurve2D)
-
Points Along 2D Curve (ISDwgPointsAlongCurve 2D)
-
Point at Corner Cut (MHDrawingPGCornerCut)
-
-
To manually edit the .xml file, you must first specify the locations tag. Then, specify the location id. Enclose the attribute within the following .xml tag.
<locations>
<location id="12" .../>
</locations>