Sets the control points used to place a weld symbol on an object and the position along the curve at the control point. This module is used with the Weld Label Text (DrawingGAWelds) geometric analyzer.
Usage in Label Template XML
<pointGeneratorSettings>
<pgModule>DrawingPGWelds</pgModule>
<pgModuleSettings>
<locations>
<location id="1" target="0" />
<location id="12" target="0" curveRatio="0.25" />
</locations>
</pgModuleSettings>
</pointGeneratorSettings>
Customization
location id
Determines the location of the point that the software places on a straight or turn feature.
XML value |
||
---|---|---|
Center At the centroid of the area of a closed shape (that is, the geometry must be a closed curve). The centroid cannot be on the curve. |
0 |
|
Middle At the middle point of a curve. |
1 |
|
Inmost At the innermost point inside the area of a closed shape (that is, the geometry must be a closed curve). |
2 |
|
At first end At the first end point of curve. |
3 |
|
At second end At the second end point of curve. |
4 |
|
Right On the right side of the range box for the curve. |
5 |
|
Left On the left side of the range box for the curve. |
6 |
|
Top On the top of the range box for the curve. |
7 |
|
Bottom On the bottom of the range box for the curve. |
8 |
|
Box center At the center of the range box for the curve. |
9 |
|
Default location Default location for the curve. |
10 |
|
At curve ratio At the curve ratio along the curve. |
12 |
|
Used with the curve ratio property. Used with positioning modules that use their start curve ratio and end curve ratio property. |
target
The curve used for determining location.
XML value |
||
---|---|---|
Default target Places points on the first curve of the 2D representation of the 3D object. The first curve is assigned internally by the software and is not predictable. |
0 |
|
All curves Places points on all curves of the 2D representation of the 3D object. |
1 |
|
Longest curve Places points on the first longest curve of the 2D representation of the 3D object. |
2 |
curveRatio
Point along the 2D curve when you use location id 12, specified as a ratio along the length of the curve. The value must be between 0.0 and 1.0.
curveRatio is used when location id is set to 12 (at curve ratio).