-
Click Select on the vertical toolbar.
-
Set the Locate Filter to Wall Systems.
-
Select the wall to which to add the fillet corner.
-
Click Select a Path on the Place Wall Ribbon.
-
Click Sketch 2D on the ribbon.
-
Click Draw .
-
Click Fillet on the vertical toolbar.
-
Place the fillet on the wall path by identifying the two sides for the fillet and then the radius.
-
Click Add or remove graphic from a group on the Change toolbar.
-
Click Select Graphic Group on the ribbon.
-
Select the original wall path. Be sure to use the Bottom Up option during selection.
-
Click Select elements to add to group or remove from it on the ribbon.
-
Select the fillet segment of the wall path that you just placed. Be sure to use the Bottom Up option during selection.
-
Click Add on the ribbon.
-
In the 2-D environment, click Close .
-
Click Finish.
-
Set the wall system, type, composition, and other properties.
-
Optionally, click Select Boundaries to limit the height of the wall.
-
Click Finish to place the fillet in the wall.