Place a trench by top cardinal point, start depth, and end invert elevation - Intergraph Smart 3D - Help - Hexagon PPM

Intergraph Smart 3D Civil

Language
English
Product
Intergraph Smart 3D
Subproduct
Civil
Search by Category
Help
Smart 3D Version
13
  1. In the Grids task, create grids as needed for drawing the trench path.

  2. In the Civil task, click Place Trench Command .

  3. Click Path on the Place Trench Ribbon, and define the path of the top of the trench.

  4. Select a cardinal point at the top of the trench: Top Left , Top Center , or Top Right .

  5. Select Define start depth and end invert elevation Civil Define start depth and end invert elevation ICON as the placement method.

  6. Type a value for End Invert Elevation. The value of the invert elevations should be less than the elevation of the 3D Sketch path.

  7. Select the parent system of the trench run.

  8. Select a trench type and its respective cross-section.

    The start depth is defined by the cross-section.

  9. Click Finish to create the trench. An example trench elevation is shown below.

    1 - Drawn trench path with varying global Z-coordinates along the path

    2 - Defined top cardinal point for cross-section

    3 - Defined start depth from trench cross-section

    4 - Defined end invert elevation

    5 - Defined footing thickness from trench cross-section

    6 - Invert elevation computed between (top cardinal point - start depth) and end invert elevation

    7, 8, 9 - Trench depths computed by (global Z-coordinate of drawn path) - (invert elevation)