Place a trench by top cardinal point, start invert elevation, and bottom slope - Intergraph Smart 3D - Help - Hexagon PPM

Intergraph Smart 3D Civil

Language
English
Product
Intergraph Smart 3D
Subproduct
Civil
Search by Category
Help
Smart 3D Version
13.1
  1. In the Grids task, create grids as needed for drawing the trench path.

  2. In the Civil task, click Place Trench Command .

  3. Click Path on the Place Trench Ribbon, and define the path of the top of the trench.

  4. Select a cardinal point at the top of the trench: Top Left , Top Center , or Top Right .

  5. Select Define start invert elevation and bottom slope Civil Define start invert elevation and bottom slope ICON as the placement method.

  6. Type a value for Start Invert Elevation. The value of the invert elevations should be less than the elevation of the 3D Sketch path.

  7. Select the parent system of the trench run.

  8. Select a trench type and its respective cross-section.

  9. Type a value for Bottom Slope.

  10. Click Finish to create the trench. An example trench elevation is shown below.

    1 - Drawn trench path with varying global Z-coordinates along the path

    2 - Defined top cardinal point for cross-section

    3 - Defined start invert elevation

    4 - Defined slope

    5 - Defined footing thickness from trench cross-section

    6, 7, 8, 9 - Trench depths computed by (global Z-coordinate of drawn path) - (invert elevation)