Create Profile Geometry Groups - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D 2D Symbols

Language
English
Product
Intergraph Smart 3D
Subproduct
2D Symbols
Search by Category
Reference Data
Smart 3D Version
12 (2018)

For each symbol representation to be created, perform the following steps:

  1. Sketch each representation on a separate layer. For more information, see Sketch and Constrain Profile Cross-Section Geometry.

  2. Shift-click to select the lines and arcs that define the contour of the profile. Do not select points, construction lines, dimensions, or constraints.

  3. Click Group on the Change toolbar.

    The geometry for the group must be selected in order in a clockwise direction. As geometry is picked, the contour should always form a continuous curve. Good practice is to start at the origin point and go clockwise around the contour, ending on the origin point.

For more information, see Cross-Section Symbol Representations.

It is easier to select the geometry for each group by having only one layer at a time displayed. Click Layer Status and select Active Layer Only. You can then display each layer individually.