Name Collar Edges - Intergraph Smart 3D - Reference Data - Hexagon PPM

In order for the software to assign the geometry in your symbol to the correct parts of the collar, you must name each geometric element in the symbol.

• All edges must be named according to the naming conventions in Edge Names.

• Collar edges that are connected to the profile are given the name of the corresponding profile edge.

1. On the Collar Symbols toolbar, click Name Collar Geometry to display the Name Edges of Clip/Collar Contour dialog box. By default, Representation Geometry Only is selected, so only geometry in the collar symbol representation will be shown.

2. In the Attribute name box, choose EdgeName.

3. Select a Geometry Type in the table. The corresponding graphical line highlights in the symbol.

4. In the Value box, select the appropriate edge name. In this example, the left side of the collar is chosen to correspond with the name Web_Right.

   

5. Click Apply.

6. Repeat until all edges of the collar are named.

7. Click OK.

Check that profile, slot, and base plane curve edge names were properly copied in with the geometry. Clear Represent Geometry Only in the Name Edges of Clip/Collar Contour dialog box to see all edges names, and add edge names if needed.