Use the Buffer to Scope Items - Intergraph Smart P&ID - 10.0 - Administration & Configuration - Intergraph

The buffer in the Project Management table allows you to make a preliminary selection of items that you want to scope.

1. With the Project Management table in an As-Built plant open, do one of the following:

   • Click on the Project Management toolbar.

   • Right-click in the Project Management table and then click Show/Hide Buffer.

2. Drag the required items one-by-one to the buffer in the Project Management table.  You can drag items from any of the following:

   • Electrical Index

   • Electrical Engineer

   • EDE

   • a schematic

   • a single line diagram

3. In the Buffer, click the check boxes next to the items that you want to scope.

4. Do one of the following:

   • Click on the on the Project Management toolbar.

   • Right-click in the Project Management table and then click Paste from Buffer.