Use a limit box as a clipping tool to work with a small area of points. The Quick Limit Box tool uses a single selection in the TruSpace viewer to define the center of the area in which to work. A limit box is applied with a pre-defined size around that center.
-
Open a TruSpace viewer from which the region of interest is visible.
-
Enable Quick Limit Box.
-
Adjust the range of the Quick Limit Box.
-
In TruSpace, switch to the Quick Limit Box mode
-
In the TruSpace viewer, select the required center point.
The CAD viewports are updated with the corresponding limit box.
-
Click Accessories > CloudWorx > Regenerate Point Clouds to load more points for the viewport and get more details.
-
Click Accessories > CloudWorx > Reset Clipping to disable limit box clipping.