Flange Dimension Lookup
Opens the Flange Dimension Lookup Dialog, which allows you to define general flange properties for weld neck flanges. The software then fills in flange and gasket dimensions with the closest standard size.
Real Curved Surfaces Diameter (dG0)
Defines dG0, the effective gasket diameter.
|
Adapted from Figure 3, EN 1591-1:2001+A1, Flanges and their joints - Design rules for gasketed circular flange connections - Part 1: Calculation method |
Gasket ID (dG1)
Defines dG1, the inside diameter of the theoretical contact area of the gasket with the flanges.
|
Adapted from Figure 3, EN 1591-1:2001+A1, Flanges and their joints - Design rules for gasketed circular flange connections - Part 1: Calculation method |
If you use Flange Dimension Lookup , the software defines a value for this field.
Gasket OD (dG2)
Defines dG2, the outside diameter of the theoretical contact area of the gasket with the flanges.
|
Adapted from Figure 3, EN 1591-1:2001+A1, Flanges and their joints - Design rules for gasketed circular flange connections - Part 1: Calculation method |
If you use Flange Dimension Lookup , the software defines a value for this field.
Material Type
Defines the gasket material category. Select Metallic or Non-Metallic.
Table Index
Defines the EN 1591 gasket properties table. The software uses the selected table only when you are using Annex G.
Gasket Type and Material
Defines the type of gasket and the material used. Select one of the following values:
-
Rubber
-
PTFE
-
Expanded PTFE
-
Expanded graphite without metal insertion
-
Expanded graphite with perforated metal insertion
-
Expanded graphite with adhesive flat metal insertion
-
Expanded Graphit and metallic sheets laminated in thin layers withstanding high stresses
-
Non-asbestos fibre with binder, eG < 1mm
-
Non-asbestors fibre with binder, eG >= 1mm
Axial Thk (eG)
Defines eG, the thickness of the gasket.
|
Adapted from Figure 3, EN 1591-1:2001+A1, Flanges and their joints - Design rules for gasketed circular flange connections - Part 1: Calculation method |
Cross Sect Curve Radius (r2)
Defines r2, the radius of curvature at the gasket cross-section.
|
Adapted from Figure 3, EN 1591-1:2001+A1, Flanges and their joints - Design rules for gasketed circular flange connections - Part 1: Calculation method |
Form Type
Defines the construction and shape of the gasket. Select Flat Gasket, Metal Gasket, Ring Joint Metal Gasket, or Metal Gasket W Curved Surfaces.
Sealing Face Inclination Angle (phiG)
Defines jG, the angle of inclination of the sealing face, in degrees.
|
Adapted from Figure 3, EN 1591-1:2001+A1, Flanges and their joints - Design rules for gasketed circular flange connections - Part 1: Calculation method |
Numerical Constant for Gasket Type (c1)
Defines c1, the numerical constant for a gasket type, such as 1/20 for a fiber-based sheet gasket.