Specifies the hot modulus of elasticity for the tank.
Typical units (depending on your unit system):
-
lb/in²
-
N/mm²
-
KPa
If this value is left blank, the software uses a default value of 0.2950E+08 lb/in² or 0.2034E+06 N/mm².
Specifies the hot modulus of elasticity for the tank.
Typical units (depending on your unit system):
lb/in²
N/mm²
KPa
If this value is left blank, the software uses a default value of 0.2950E+08 lb/in² or 0.2034E+06 N/mm².