The software displays different prompts based on the selections you make. Different scenarios you might encounter are described in the following procedure:
-
Click Change Size
. Alternatively, type CHANGESIZE on the command line, and press ENTER.
-
Press ENTER for automatic.
-
Select a component.
The software displays a list of sizes.
-
Select a size from the list.
If you select a size that is not available in the catalog for a component, the software
stops the process and you must restart.
-
Select each branch in the model, and then select a size from the list. Follow any prompts the software displays.
-
If you select a branch size that is not available for a component in the selected branch, the software prompts you to change the component. The process fails if you select No.
-
If you select only one branch, the software prompts you to either change the component, add a reducer, or cancel the process.
-
If you select a line size that does not match the selected main line size. The software may prompt you to insert a reducer on that line.
-
The software displays prompts based on you selections.
-
Select a component, or press ENTER to finish.
-
If the software prompts you to fix the pipe by BOP, TOP, or Current, type an option, and press ENTER.
-
Select a component to keep its position, or press ENTER to finish.
Until you press ENTER to finish, the software continues to prompt you to select a
component.
The selected system changes size.