Change the size of a reducer and the pipes automatically - CADWorx - Help

CADWorx Plant

Language
English
Product
CADWorx
Subproduct
Plant
Search by Category
Help
CAESAR II Version
12
I-Configure Version
6.0(2016)
Smart Isometrics Version
8
Spoolgen Version
10
CADWorx Version
20.1 (2020 R1)
CADWorx Structure Version
2020 R1 (4.1)
  1. Click Change Size . Alternatively, type CHANGESIZE on the command line, and press ENTER.

  2. Press ENTER for automatic.

  3. Select a reducer.

  4. Type Large, Small, or Both on the command line, and press ENTER.

  5. Select a size from the list that displays. This is based on the choice you make in step 4.

    If a size is not available in the catalog for a component the process stops, forcing you to start over.

  6. Select a component to keep its position, or press ENTER to finish.

    Until you press ENTER to finish the software continues to prompt you for selection of a component.

    The entire drawing changes its size.

If you change the size of a pipe on the small end of a reducer to the same size as the pipe on the large end of the reducer, the software gives you the option to change the component. If you do not change the component the process fails.