-
Click Thrd/SW Ecc Swage . Alternatively, type SWGE on the command line and then press ENTER.
-
Pick a starting point for the large end, such as at the end of a pipe.
-
Click in the direction of the small end of reducer.
-
To place the flat side in the X-Y plane, click in the direction of the flat side.
or
To place the flat side in the Z direction, select Up or Down.
-
Specify the end type connection at the large end of the reducer.
Type the required alpha description.
-
Specify the end type connection at the small end of the reducer.
The reducer component is drawn.