Thrd/SW Fittings toolbar: Thrd/SW Pipe
Command line: PIPF
Places a pipe component in the X-Y plane.
If the drawing environment is set to threaded, the piping component has threaded ends. If the drawing environment is set to a socket weld, the piping component has plain ends.
Ends
Specifies the end options for the starting and ending of the pipe.
-
Threaded
Used when working with threaded pipe. The threaded default option appears when the environment is set to threaded mode. For more information, see Setup Size/Spec Panel.
-
Bevel
Used when working with welded components.
-
Plain
Used when working with threaded pipe. The threaded default option appears when the environment is set to threaded mode. For more information, see Setup Size/Spec Panel.
last point
Starts the pipe at the last point of the previously-created component.
TOP
Places the pipe along the top of the pipe, as defined along the Z-axis.
BOP
Places the pipe along the bottom of the pipe, as defined along the Z-axis.
Right
Places the pipe along the right side of the pipe, as defined along the Z-axis.
Left
Places the pipe along the left side of the pipe, as defined along the Z-axis.