-
Click Auto Route . Alternatively, click the plus grip point to continue routing.
-
Type B on the command line or select elBow type.
The elbow type list displays.
-
Select Miter Elbow Buttweld. This selection is determined by the router type. Right-click Pipe in the CADWorx Spec View palette to change the router type. For more information, see Draw pipe components.
-
Route the piping.
The software routes mitered elbows.
If you stop routing and then start routing again on the same line, the software continues to route mitered elbows. However, if you stop routing and start a new route from a different location, the software resets the elbow type. If you want to only route one mitered elbow, then you can use the component List and place an elbow from Elbows > Mitered Elbow.