Command line: CWPEDITPIPESLOPE
Specifies the slope of an existing pipe in the drawing. This command displays the Edit Slope dialog box.
Choose to edit the slope for Component Only or Pipe Segment.
Edit Slope Information
-
Pipe Segment Start Point
Specifies the first point of the selected pipe.
-
Redefine
Redefines the start point to use for editing the slope.
-
Pipe Segment End Point
Specifies the last point of the selected pipe.
-
Redefine
Redefines the end point to use for editing the slope.
-
Rise
Specifies the distance the selected pipe travels vertically.
-
Length per unit
Specifies the distance the selected pipe travels horizontally.
-
Sloped Angle
Specifies the angle of the selected pipe.
-
Anchor Point
Specifies which end of the selected pipe remains unchanged when you edit the pipe slope.
-
Slope Direction
-
Up - The elevation increases starting from the anchor point.
-
Down - The elevation decreases starting from the anchor point.
-
Horizontal - There is no change in elevation.
-
-
Force skewed pipe for angle below skew tolerance
This feature forces a skewed pipe connection between pipes even if the connection is within the skew tolerance.