-
In Sketch 2D, click Place Belt Components Custom Command to open the Place Belt Components Dialog.
-
Select Equipment in the Select Belt Component box.
-
In the Symbol Directory box, specify the needed Symbol Share folder.
-
Click Place Along Tab (Equipment).
-
In the Part Class box, select the type of idler to be placed.
-
In Part Name, select the idler part to place.
-
In Count, type the number of idler parts to be placed.
-
In Offset, type the offset from the start point for the position of the first part.
-
In Spacing, type the spacing between parts when Count is greater than 1.
-
The Orientation box sets to Normal to Belt by default. If not, click Change and select a new value.
-
In the Selection Mode box, select a method for creating the start point on the belt profile.
-
In the Direction of Placement box, select a direction value.
-
Based on the specified Selection Mode, select a start point on the belt profile in the graphic view of the drawing.
After a valid selection is made, the Go button is active.
-
Click Go to place symbols for the idler parts.
-
Repeat these steps as many times as required to populate the belt with symbols for the selected part.
-
The software places subsequent parts relative to placement of the previous idler.
-
On subsequent executions, if Offset is 0, the value of Spacing is automatically used as the first offset.
-
When you place equipment and then modify the geometry of the belt profile, the equipment gets distorted. To correct the distortion use the Sync3D-2D feature to realign the components in Sketch 2D according to their positions in 3D environment.